|Check the following:|
- You have the FreeRADIUS user (freerad on Debian systems, radiusd on RHEL systems) listed in
- You are running the TIDC command as the FreeRADIUS user and that you have run the
unset DISPLAY command before running the TIDC command.
- You have imported the Trust Router credentials using the
moonshot-webp command as the FreeRADIUS user in Section 4.4.1 of Install an IdP on Debian 78 or Install an IdP on RHEL/CentOS/SL 6. To verify you have, execute
ls -la ~/.local/share/moonshot-ui/identities.txt as the FreeRADIUS user, and you should see the file listed.
- If you use Network Address Translation (NAT), check that you are forwarding TCP ports 2083 and 12309 both in- and outbound, and that the public IP address is correct in the configuration of your Trust Router operator.
- If your service is firewalled, check that TCP ports 2083 and 12309 are open both in- and outbound, and that the public IP address is correct in the configuration of your Trust Router operator. Your firewall should also support hairpinning.
- You are running the newest version of the trust router and Moonshot software. If you were part of the Janet or GÉANT Moonshot Pilots, you must update your software to the newest versions.
- You have installed the
dbus-x11 package. This package is not installed as part of the package dependencies, but it is part of the instructions in Section 2 of the platform-specific instructions for Install an Identity Provider. It is a client library and will not require the installation of the X11 system.