Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Opennav
 
Panel

On this page you will find instructions on how to install the Moonshot Libraries a Debian 9 (Stretch) device to enable its use as a Moonshot Client.

Contents

Table of Contents
maxLevel2

Note
titleAssumptions & Prerequisites

This guide assumes you have root access to the Linux device. This is required as new software needs to be installed system-wide.

Numbered Headings

System Preparation

The Moonshot client mechanism and ID manager are part of the standard Debian 9 repository. However, if you prefer getting updates directly from us, configure the Moonshot repository as well.

Add the Moonshot Repository

  1. Add the Moonshot Debian Jessie repository to your system. To do this, run the following command (as root, or using sudo):

    Code Block
    languagebash
    $ echo "deb http://repository.project-moonshot.org/debian-moonshot jessie main" > /etc/apt/sources.list.d/moonshot.list
  2. Install the Moonshot GPG key:

    Code Block
    languagebash
    $ wget -O - http://repository.project-moonshot.org/key.gpg | apt-key add -
  3. Update the apt cache with the new repository information:

    Code Block
    languagebash
    $ apt-get update

Install the Moonshot Client libraries

We’re now ready to install the Moonshot software and its required dependencies. Install the software by running the following command:

Code Block
languagebash
$ apt-get install moonshot-gss-eap moonshot-ui

Next steps

At this point, you now have all of the required Moonshot software on your device, including the Moonshot Identity Selector. Depending on what client application you are using and wish to enable Moonshot authentication for, you job may now be done, or you may need to go and install a Moonshot compatible version of the client software or configure your existing client. Check the section on client compatibility if you are unsure.