1. System Preparation
To build all of the Moonshot components, you need various packages installed. To install all of these, see below.
1.1.1. Get the required packages on Debian 8
To get all of the requirements on Debian 8 (Jessie), you will need to add the Wheezy-backports repository, and issue a couple of apt-get install commands:
Add the Wheezy-backports repository.
Refresh local package information
Install a whole load of packages from the normal Wheezy repo:
Install a package from the Wheezy-backports repo
2. Checkout the Moonshot source
The Moonshot source code is all stored in a GIT repository. To fetch it, issue the following command.
3. Build Moonshot
To build Moonshot, simply enter the moonshot directory of the git repo that you just checked out, and run the builder script. In the --prefix option, you can specify where the code will be installed to. Note that you will need to build as a user who has permission to install in the target directory, because the builder script installs during the build, instead of doing an install after the build has finished (so you can't build first as an underprivileged user and install as a superuser as you would normally do).
You probably know this, but if you stuck your installation into an unusual location, you may need to do the following (as root) - where, here, /opt/moonshot is the install path you used for the prefix option above:
(TODO: document /etc/init.d/ stuff?)