On this page you will find instructions on how to install the Moonshot Libraries on a RHEL 7 / CentOS 7 / Scientific Linux 7 device to enable its use as a Moonshot client.
This guide assumes you have root access to the Linux device. This is required as new software needs to be installed system-wide.
Turn off SELinux
There are currently no SELinux policies for Moonshot, and SELinux must be run in Permissive mode.
Add the required repositories
Moonshot requires three
Install the Moonshot Client libraries
We’re now ready to install the Moonshot software and its required dependencies. Install the software by running the following command:
At this point, you now have all of the required Moonshot software on your device, including the Moonshot Identity Selector. Depending on what client application you are using and wish to enable Moonshot authentication for, you job may now be done, or you may need to go and install a Moonshot compatible version of the client software or configure your existing client. Check the section on client compatibility if you are unsure.